Update docs
This commit is contained in:
parent
10fa71d7ca
commit
786b8e9b19
@ -17,7 +17,8 @@ I would suggest that you try how it fits into the PET tube before soldering it t
|
||||
You also need to desolder (remove) the RED ON LED from the ESP32 or the battery power will be reduced a lot.
|
||||
|
||||
Final thing is to add a resistor between A0 (Analog PIN) and ground of 470k. The reason is that the esp8266 has a build in resistor which
|
||||
the esp32 does not have. So in order to get a valid voltage (less than 3.2V) on the A= pin this is needed.
|
||||
the esp32 does not have. So in order to get a valid voltage (less than 3.2V) on the A0 pin this is needed. Once the modification is done you might
|
||||
need to adjust the voltage factor so the battery reading is correct.
|
||||
|
||||
.. image:: images/esp32.jpg
|
||||
:width: 500
|
||||
|
@ -26,6 +26,7 @@ v0.9.0
|
||||
* BUG: Temp format name was incorrect in iSpindle format causing receiver to incorrectly read temperature.
|
||||
* BUG: Temperature sensor adjusmemnt value was not handled properly when using Farenheight.
|
||||
* BUG: If the ID was to low the device id could end up with a leading space causing errors in data post. Added leading zero to ID.
|
||||
* BUG: Entering wifi setup and a timeout occured the wifi settings could be deleted.
|
||||
|
||||
v0.8.0
|
||||
------
|
||||
|
Loading…
Reference in New Issue
Block a user